Glass Plate Installation in Zortrax M300 Dual LPD Plus 3D Printer with Dual-Extrusion

Glass Plate Installation in Zortrax M300 Dual LPD Plus 3D Printer with Dual-Extrusion


Turn the printer off and unplug the power cable.
Unplug the heatbed cable and carefully remove the platform from the printer.
Unscrew the twelve screws that secure the perforated plate to the heatbed.
Next, separate the plate from the heatbed.
Clean the heatbed from material residues using a piece of cloth.
Place the glass plate on the heatbed.
Install the four corner clips and secure them with the screws.
Install the two push-on side clips.
Place the platform in the printer and plug the heatbed cable in.

One Reply to “Glass Plate Installation in Zortrax M300 Dual LPD Plus 3D Printer with Dual-Extrusion”

  1. Is this a new thing to the Zortrax? If yes may i ask why now? Even though glass can acchieve some very decent results (especially with abs), it's far from an easy to use medium to print on!

Leave a Reply

Your email address will not be published. Required fields are marked *