Automotive Radar Signal Analysis and Generation

Automotive Radar Signal Analysis and Generation


hi my name is Jacob elf I’m staff engineer at keysight technologies and we are sitting in the automotive Customer Center yeah Novi Michigan today we will be discussing it’s double that we have set up today it goes over their radar signal generation and analysis we start off by generating signal using like two similar items over here that will send it both to our UX a and a scope for further analysis now let’s take a closer look we’re gonna start over here on the left with our second generation starting with that m8195a arbitrary waveform generator it is sitting in our m95 o28 chassis that will be used to create our I have signal at 4 gigahertz wide not only sent it to a mixer below it we have a MHz analog signal generated that will be used to create the ellow signal at 12 point 5 gigahertz which will also be fed into a mix it my mixer will then act as a upconverting and convert that signal up to 79 gigahertz which we can put to that plane to the front end of our UXA signal analyzer with a sweeping special attention and 10 gigahertz from there we can view kind of the occupied bandwidth of that signal from the UXA it’s going to be down committed and sent over to our MSOs Adel for a scope in which we can use VSA to further analyze the signal with different measurements including Africa measurement time phase measurement time FM air time pretty much extension of measurements there and there you have it there’s a solution on radar signal generation and analysis to contact insight about any other questions on product selection education training please call one eight hundred eight to nine forty four twenty four or visit us at keysight.com of course you can always be challenged and here long enough time


Leave a Reply

Your email address will not be published. Required fields are marked *